5 x Raspberry Pi Zero Mini Camera Module 5MP 1080p Webcam Support OV5647 Sensor, with FFC Flex Ribbon Cable Replacement Flex Cable 30cm Including E-Book!

All 3 modules had white flex cables with a fold in them that looked as if they had been ironed flat. Not good for the flex cable. The Pi Zero cables however were fine all rolled up in separate bag. CCD module not stuck down onto PCB. Found that out when I went to remove CCD red tagged cover from lens and the whole CCD module and flex came away from pcb. The double sided sticky tape is present but no one has removed the white cover from tape side that sticks black CCD module onto the pcb. Just make sure you clip the plug and socket back together on short flex from CCD to PCB before sticking down CCD. But these are still good value for the price.

Was shopping for a Zero cable on another site. Checked Amazon and found that for another quid l could have two cables and a better camera. ☺

Beware: The camera lens (the black bit on the picture) was loose, relying on the connector (the light brown bit) to hold it in place. It was only after it broke the connection (rendering the camera inoperable) I discovered under the camera lens was a bit of sticky tape covered by a white paper square that had to be peeled off to stick the lens to the circuit board. No where in the documentation was this mentioned but I now have an impossible task to prove the lens was insecure but in the meantime my new Pi video camera is totally defunct and unusable.