Clamp Saddle "Don't Screw-up the Glue-up"

Description

The TiNTiC Clamp Saddle fits all major brands; Bessey, Jorgensen, Jet, and Irwin parallel bar clamps. They easily snap on and fit snuggly to the parallel bar clamp but are also easy to reposition. They suspend the glue joint above the clamp bars and shed the dripping glue away from the clamps. There is a raised shoulder on each end which prevents the glue joint from making direct contact with the clamp, thus preventing messy glue smear on your clamps and woodworking projects. They are designed with a 1" valley for the application of standard masking tape if desired, however they are constructed of rugged polypropylene which is highly resistant to most wood glues making the removal of dried on glue a cinch. This 1" valley also has a button in the center so you can set the first glued edge of a board down and lean it against the jaw of your clamp while spreading glue on the opposite edge without getting excess glue on your clamps or other working surfaces. Use them again and again in your woodworking projects including; panel glue ups, cope and stick joints for cabinet doors, and box joints. The TiNTiC Clamp Saddle is manufactured in the USA and sold individually in the TiNTiC Amazon store. The quantity you need for your woodworking project will depend on the number of clamps being used and the number of boards being glued. The following equation can help you calculate the required quantity needed for your project. (Boards x Clamps + Clamps = TiNTiC Clamp Saddles) "Don't Screw-up the Glue-up"