1 Pack Rectangular Recessed Sliding Door Handles Concealed Door Drawer Finger Pull Sliding Barn Door Handles and Pulls

I ordered 10 pack, all but 1 were twisted/bent by 1/32 to 1/16" across the flush face of the product if you measured them diagonally. You will notice this if you install them in a door that gap around the perimeter of the face of the product isn't consistent. No it's not the expensive oak doors I put them into nor is it the mortise into the door that is causing this problem. So you will see that one corner when mounted is lifted from the door face by as much I mention above. I checked the bend/twist of them by laying them all on the face of a 4S piece of quality wood for reference. This bend looks crappy and make as nicely finished door look bad and cheap, especially with a 1/16" of a gap on a corner. I had to take them, protect the finish with wood pieces and put them in a vise and unbend the flaw out of them so they sit flat and look good. The cup portion is tack welded onto the flat front piece that is bent so I'm not sure if it is a heat issue/difference between the two pieces when they are joined but again 9 of 10 pieces came bent or twisted in respect to diagonally across the face of the product. The manufacture needs to fix their manufacturing process to prevent this, otherwise, the product is nice. Good finish, the insides are a little sharp but no enough you worry about getting a cut.

These have a nice solid look and feel to them. I used a router to notch out the wood and they just simply work. The screws that come with it are pretty small and function fine since their only function is to keep the handle from falling out and not needed for any kind of structural support. Nice smooth interior so no worries about getting cut. I added my video of the interior door lock I used on my barn door but I did it because it shows the handle briefly. I can't seem to get my photo to rotate right side up? Sorry

Nice quality. Nice finish. My contractor said they are difficult to install. Screws are hard to install due to design. But they are installed and look beautiful.

These are heavy and well-made. They'll require some specialized tools or a lot of manual chiseling but once installed they'll look really elegant.I did order two few as, having glanced over an "answered question" it looked like I was buying five 2-packs. I need eight so I'm returning the five and getting a 10-pack.

not very practical, does not come with any screws...will need to use glue to hold into doors, will likely not bother installing

Nice, basic door pull. We mounted this on a pocket door and it looks great and works well. The inner edges of the finger area are straight cut and a bit sharp.

Excellent finish in stainless brushed. Mounted into a solid core barn door so when it's fully open it clears the door frame. Could also be used as a recessed drawer pull handle.

Every single one is warped diagonally. This makes them useless for pocket doors or any situation where flush mounting is important. They were cheap because I am guessing these are factory rejects.