Carbide Tip Adjustable Circle Cutter with Plain Brad Point Drill, 4mm Hex Key Wrench, 1-1/4'' Drill Bit and 2 Cutting Blades

For some reason this very useful tool is not available at our local big box hardware stores. I needed a tool for cutting a few discs out of plexiglass without requiring a center hole or scratching it up. The local stores have only fixed size hole saws, none of which were the size I needed.The only tricky part was getting the hole accurately sized, since the two cutters on this tool move independently. It took several tests (I used scrap wood) to get the sizing right. A drill press was essential for this because I needed to flip the plexiglass and cut in from both sides to get a clean cut. The results are very good.

Works good but once this catches the materical brace your wrist its a wrist breaker for sure if your not ready. It also leaves a bit of a curved beveled edge and sanding is required

Have not used yet .I thought it was shown for thin sheet metal but the package saids plastic or wood looks like it will do the job I need

It cuts well, but seems to stick from time to time. After cutting out three 1/8 craft plywood centering rings and one 1/4" craft plywood centering ring, the blades have dulled badly. Will most likely look for another brand in the future.

Worked as I expected. It rattled very little as I was drilling with it. Definitely use in drill press. Would recommend to buy

good product

The product is listed as carbide tipped. This is not true. It may be high speed steel but I doubt it. I would definitely not recommend buying this!

I use this to cut speaker holes in a variety of materials from plastic to hard wood. It works beautifully. Run the drill slowly, I use a press.