Timothy Seeger 10 Honda & Acura Bumper Clips Accord Civic CR-V MDX RDX

Warning....These clips are not as long as the OEM style clips. I used these to reinstall the front splash guard on my 2009 Honda Civic LX. I could not get the center pin down into the "locked" position when there was more than one plastic splash panel that had to be sandwiched together with this clip. On most of these splash guard panels, you need to put the clip through one or more panels and then secure it to the body or bumper assembly. I ended up removing the metal retaining clip inside to get the center pin to seat further into the clip. Once I did this, I was able to lock two panels together and secure it into the hole in the body/bumper. Even without the metal retaining clip installed the center pins locked securely into place and held all the panels in place. It would have been nice if these were a little longer, but they did get the job done.

Purchased these to replace some of the clips on the lower side of the bumper on my 2008 Honda Civic. The clips work just fine with one little issue which is not the fault of the seller. These clips come in three pieces. The Body, Pin and these metallic like hooks. Pin going into the body is just fine but you need to install the metallic hooks in between the pin and body...that's where it becomes tedious. Once you've gotten all three pieces assembled, you're good to go.

It's difficult to order clips online to fit your car, since you don't get to touch and feel them. Every once in a while I get the wrong ones, but at the price it's a low risk. I bought these for a Honda Civic and they ended up fitting pretty well. Likely these aren't exactly the same as the factory originals, but they work and that's what counts.

These are equal to the bumper clips/pins you would normally buy at the dealership. The ones at the dealership are about $1.50 each plus tax. These are a bargain and are necessary if you do any work on your car yourself. They are also good to have on hand in case one falls out or gets lost by some mechanic who is not paying attention.

The water pump pulley flange broke on my 2006 Civic, necessitating removing the front valance pan and left fender liner for repairs. Of course over half of the factory clips broke upon removal. I ordered these clips through Amazon, and they were shipped by Fischic the next day. These clips are a more robust clip than the factory ones, include the metal liner, and were much cheaper. They work perfectly for the front valance pan, but are too large for the fender liner as they are smaller in diameter. A really good buy.

First time using these clips and I found them to be excellent and high quality. They came assembled and ready to use. A few of them required the center pin to be pulled out slightly to retract the metal retaining side clips but no big deal. Highly recommend. It is not uncommon to find the under radiator dust shields missing pins that come into the shop. These fit perfectly and I know they will stay in place.

Just like OEM for the splash shields to a 2004 Acura MDX, although there are TWO different designs, so I had to improviose with the smaller diameter ones as these were too large to fit, but the replaced the other fasteners perfectly.

I brought wrong one. Not fit for my honda civic. But as I already use it, it can't be return any more.