Replace parts Stainless Steel Heat Plate(10-965) and Burner w/Screw(10-957) Replacements for Magma a10-803, a10-918l, a10-918ls, a10-1218l and a10-1218ls Grills

Part fit perfect!! Well built..

This part is not a factory made part. The holes are not the same. There is no detent to hold the regulator in the burner tube. No instructions to assist with modification. It would’ve been much easier to spend 20 extra dollars and get the American made part from Magma. Sorry Magma.

Exact fit, change out took 10 minutes. But I am a little disappointed how quickly the burner wears out.

There was no dimple in the burner to hold the regulator in place. Otherwise, would have been 5 stars. (A hammer and center punch did the trick).

Product doesn’t fit as intended. Missing nipple that holds regulator in place definite safety hazard. Don’t purchase this as a Magma replacement parts. Very deceptive as I was looking for Magma replacement Parts.

Ok people here is my honest assessment. I'm an experinced cruiser who does most all of my trawlers repair and maintenance. I read the reviews before I bought this magma knock off burner and shield kit. I asked the seller after reading reviews if the burner had the needed nipple that locks the regulator in place so it doesn't fall out he replied yes so I bought it. Well it does not in fact have the indent / nipple so let me tell you what I had to do to make this work. Most people should be able to do these modifications in order to use this kit and save a good bit of money instead of buying factory OEM. I will say the quality of the stainless the metal is good. Now I had to do the nipple or indent for the regulator by using a good punch if you will, I measured the old one and the placement which is about 20 inch away from the air intake area use my punch and a hammer and made the indent myself and it worked like a charm actually looked factory. Now I had to use a Dremel and a cut-off wheel to modify the brackets of the heat shield in order for it to fit and sit down properly over the burner. The new one sits approximately 3/8 above the burner. Overall simple modifications but all said and done looks good fits good and you save a good bit of money. If you don't want to modify it don't buy it by OEM. I hope this helps someone out there. vote 45 in 24. Capt gman

No issues with this product. Performed as it should

I really appreciated the feedback on the size of the items included in the purchase, the unit I had was an older unit with no part numbers or id of what model it was.

Replaced OEM parts on BBQ. Good fit, easy install and less money than OEM. Very pleased.

Delivery was quick, install easy and now my 7 yr old bbq is working as good as new.

Good value but I needed to modify the burner so the requlator would stay in placeHeat shield fits and looks good

Arrived broken, shipped a brown paper envelope. No box or padding, so the tiny and weak spot welds were broken on all the tabs.The burner tube, as mentioned by others, is missing the indentation to hold the regulator in place and bottle falls out of bbq during use, very dangerous. waste of money.......

The burner is useless and dangerous as it is missing the indentation that secures the Magma BBQ regulator.However, The included steel heat plate seems to install just fine.