RAMPS 1.4 CONTROLLER is available now from our US and UK warehouse Free shipping to US and UK in 3-6 business days ship to Canada, Brazil in 7-10 days in US warehouse ship to European countries in 7-10 days in UK warehouse 3D Printer Controller For RAMPS 1.4 Reprap Mendel Prusa Support Arduino Boards Description: Fully assembled & tested, no soldering required It is designed to fit the entire electronics needed for a RepRap in one small package for low cost The modular design includes plug in stepper drivers and extruder control electronics on an Arduino MEGA shield for easy service, part replacement, upgrade-ability and expansion A number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack Size: Approx. 11.5 x 6 cm / 4.53 x 2.36 inch Package included: 1 x 3D printer controller for RAMPS 1.4
L**Z
Board had so many bent pins and poor placement of connectors that I had a hard time ...
Board had so many bent pins and poor placement of connectors that I had a hard time connecting it to my Arduino board as well as connecting the motor driver boards. to connect my Z motors and thermistors, I had to first put in one motor, then the thermistors, then torque the two apart to make space for the other motor.Avoid this board at all cost
A**R
Seems to work fine. Solder joints were good except for a little ...
Seems to work fine. Solder joints were good except for a little bit of solder on the hole for the 12 volt fan. One of the ceramic capacitors seems to have been replaced and is not straight and was re-soldered a bit sloppy. Otherwise a good value and I am using it now..
M**K
Would buy again.
Works great arrived quickly. One of the headers was soldered on at an angle but I was able to get it connected. For the price I can't complain, fit and finish was on par.
A**R
but bent back easily. It's been running since January with no problems
Been using this board since I shorted my last one. It's been running for Pins were slightly bent on the display header, but bent back easily. It's been running since January with no problems.
A**N
Using this right now for my MendelMax 1. 5A ...
Using this right now for my MendelMax 1.5A. I've swapped fuses for heavy-duty automotive fuses and am running it over top of a Taurino board.
J**Y
Dead on arrival.
Wired it up, only to find that T0 and T1 don't work. Waste of time.
I**G
Thin Solder, Be Careful.
Solder too thin at power supply connection, caused too much resistance, caught fire. However, the first one I bought had sufficient solder. So...who knows...
A**R
Five Stars
as described
Trustpilot
3 weeks ago
2 months ago
