SKITCH Precision Fast Spin Bearings Set | 8 Pack 608 2RS ABEC 9 Chrome Steel Deep Groove Ball Bearing Set for Skateboards, Longboards, Inline Skates, Scooters | + Washers + Spacers | 8mm x 22mm x 7mm

Very good bearings for the price, wasn't expecting these to be this good. Very easy to set up. Are very fast, and roll over cracks easily. Very silent. Are good for skateboarding. For the price you can't go wrong. I have bought other bearings for around the same price as these and they were terrible. This was a pleasanst surprise I needed bearings asap didn't have the funds for my go to brand, and these provided a great quality at a great price, which I was not expecting from past experience with other brands priced around the same as these. Top notch stuff.

As a noob skater dont forget to buy 2. This is for 1 skate. Other then that the bearings are very good and smooth. See how long they last

Very good! Thank you!

They are very clean and what’ve lots of lubricant. They look cool and hardy and very quiet plus a smooth ride. They definitely make my wheels go faster for a longer period of time! So far they seem durable.

Excellent Baron good price roll smooth with roller skating wheel

Out of the box, they showed medium results. The wheels rotated for approximately 7-8 seconds without lubrication. After adding 3-4 drops of nano oil-85, approximate 10-11 sec. I will experiment with other oils later. The old bearings, which were in very poor condition, showed approximately the same result (6-7 sec, no lub). I tried several models in the same price range, and the oter brand turned out to be better. But I would recommend trying more brands before making a decision.

Great bearings at a great price. Spacers and speed washers included. They are ready to go out of the box. Spin smooth and quiet. Just started riding them so they aren't really broken in yet. Sealed on both sides so they can be cleaned and lubed with your choice of products. I'm not a speed rider or a trick rider; there are great for me. replaced old abec7s.

They aren't bad actually, especially for the price. Are they the best ever? No but they're good and they're half the price. You have to install them correctly and oil then, that's the key. What I did was wiped off the packing grease and applied WD40 to each side of all the bearings. I let the oil penetrate, then spun them in both directions and applied more WD40. I did this 3 times. After that, just watch a YouTube video on how to correctly install bearings in skateboard wheels. You essentially just push one on the outside of the wheel really hard. I covered mine with an old shirt and lightly tapped on the outer bearing with the wooden end of a hammer to set it farther in. Then I put the speed washer the inner bearing, and the spacer on the axel, and I pushed really hard on the wheel until I could get the axel nut on. Then I tightened the axel nut all the way to set the bearings all the way in the wheels then I backed out the nut so the wheels spun. Easy peasy. 👍

son silenciosos pero no giran tanto como esperaba

Bought to replace worn out bearings on my sector 9 long board. Quite fast and smooth once broken in. Only took one session to break in. Not sure if they will last as long as reds but time will tell. Good bang for the buck

Los saqué del empaque, se los puse a mi patineta y ruedan bien, sólo que al rodar hacen ruido como de que están rosando. Pude resolver el problema limpiando y lubricándolos. Son un buen producto y está genial que se puedan abrir por ambos lados.

Buenos, Bonitos y Baratos. La verdad son unos baleros muy sencillos, nada llamativos y cumplen su función. Me sacaron de un apuro cuando los que tenía mi surfskate quedaron muy sucios. Llegaron en la fecha pactada y en excelente estado.