Size:BNF FRSKY R9MM  |  Color:F4 Feature introduction: F722 flight control, STABLE PRO F722 DUAL BL32 35A (advanced version) F405 flight control, STABLE V2 F405 30A (basic version) Wheelbase: 115mm Motor: 1105 5000KV motor Weight: 127g (without battery) Please know: This drone do not include battery, the recommend battery is 4S 450-650 mah battery. STABLE PRO F722 DUAL Gyro ICM20689 Version: · Flight Controller: Model:STABLE PRO F7 35A MCU: STM32F722RET6 IMU: 2x ICM20689(SPI) BlackBox: 32Mb onboard Flash OSD: BetaFlight OSD w/ AT7456E chip Firmware target: EXF722DUAL Integrated LC Filter Size: 26x26mm board, 20mm mounting holes (M2) · ESC BLheli_32 2-6S 4in1: MCU:STM32F051 Constant:35Amps Burst:45Amps Mounting Holes:20*20mm,M2 Supports Dshot1200,Proshot,Oneshot,Multishot Current meter: Yes Target: GEPRC-BL32-4IN1 · 5.8g 500mW VTX: Input voltage: 5V Channel: 48 Power transmission: 0mW(Pit mode) / 25mW / 100mW / 200mW / 400mW/ 500mW Connector type: MMCX Connector Traditional button IRC Tramp protocol STABLE V2 F405 Version: · Flight Controller: Model:STABLE V2 F4 30A MCU: F405 IMU: MPU6000 gyro/accelerometer (SPI) OSD: BetaFlight OSD w/ AT7456E chip Baro:NO BEC Output: 5V@3A Integrated LC Filter Firmware target: OmnibusF4SD · BLheli_S ESC 2-5S 4in1: MCU:STM32F051 Input:2-6s lipo Constant:35Amps Burst:45Amps Supports Dshot1200,Proshot,Oneshot,Multishot Current meter: Yes Target: GEPRC-BL32-4IN1 · 5.8g 500mW VTX: Input voltage: 5V Channel: 48 Power transmission: 0mW(Pit mode) / 25mW / 100mW / 200mW / 400mW/ 500mW Connector type: MMCX Connector Traditional button IRC Tramp protocol
G**D
A well made and fun quad but know GEPRC does not back there product.
A well made and fun quad but know GEPRC does not back their product.This quad is so much fun. It’s a small and very nimble design with plenty power on 4S. It does handle a crash very well. The small size and light weight definitely help in a hard landing.My camera did burn out after about 3 weeks. With lots of back and fourth trying to get the camera replaced I received “The pictures look dirty” so it’s not in like new condition. Trust me it looked like it just came out of the box and of course I cleaned it before the pictures. From my FB post someone said “He must have superman vision. What dirt. Bs to get out of fixing it”. So your on your own after buying!
K**N
Absolute Garbage!!!!
This so-called "BNF" drone arrived to me with one of the motor wires broken off from it's shabby solder joint. I had to extend the wire because it was cut way too short. NOTHING was set up on this drone... the motors were all running backwards, the props were on wrong! I will NEVER buy another drone from Amazon or GEPRC!!!
T**D
IF you can get one that works great!!!
well mine came right form the manufacturer, I ordered a flysky, they sent me this, Came with a crossfire receiver, NO caddx wiring harness, Props on backwards, too small of battery strap, had to use 2 velcro straps to hold battery on, power cable barely long enough, monopole antenna(Really!!). Installed foxeer lollipop, the cores always says they are over heating even when flying, they run at 150-170 degrees all the time. Caddx camera is great, the emax avan props are top notch, frame and parts build is stellar put together, all 3mm carbon fiber, with aluminum for the camera mount. Plastic really stiff for the indux, get extras as 1st hard landing or crash they will break. Flys pretty good, strong motors, 3 or 4 cell batts, from 525mah to 650 size for over 4min. of flight. 1105-5000kv motors.
B**D
Not a good company
Bought mine directly from geprc and as they were happy to take my money it said it would be mailed to me in a couple weeks that was 3 months ago and it has not left the warehouse yet,I understand there is a pandemic but they should warn you there is no one minding the store.
Trustpilot
3 weeks ago
1 day ago