BTF-LIGHTING 3 Pin 32.8ft/10m 18AWG WS2812B WS2811 RGB Electrical Extension Cable LED Strip Light Ribbon Wire Connection 3 Core Cord Line for WS2812 Color Changing Flexible LED Tape Rope

I recently wrapped up a project that involved setting up outdoor RGB LED light strips. Going against the usual advice from manufacturers not to cut the strip, I found myself with no other choice for my specific setup. The real trick was to install the wires discreetly while keeping the lights working perfectly. After trying out a few different options, I stumbled upon the BTF-Lighting 32.8ft/10m 3 Pin 18AWG Extension Cable, and honestly, it was a total game-changer for the project.This particular extension cable is tailor-made for WS2812B, WS2811, WS2814, SK6812, and other similar RGB LED strip lights. Its versatility makes it a great fit for various LED projects. What really impressed me about this cable was its dependability and how user-friendly it was. I was initially pretty hesitant about splitting my LED strips, but this extension cable made the whole process seamless and stress-free.I was genuinely impressed with the wire quality. It’s 18AWG, which is sturdy enough to handle the power needs without causing any voltage drop-off. This means the LED lights work just as they should. The length of the cable, at 32.8 feet, gives plenty of room to work with, allowing me to route the cables just where I needed them, no compromises.If you’re in the market to extend your RGB LED light strips, this is the only product I’d feel confident recommending.

As described, strong wire when needed to pull on it a bit.

a advertised

Very good quality. Used to build a LED strip light parallel circuit.

I just love to solder this to almost any of my LED strips and more, unlike all those other spools of aluminum wire consisting of a gazillion of strands. Even if I don't need this exact 5-wire standard, I just split it and leave as many as needed for my project.

the "20awg" is not accurate, looks more like 22 or smaller, the main issue is that the pvc coating is too thick for their own connectors! So you can't even use with there crimp connectors, not sure why they are selling this instead of the wire they use as part of there connector packs.Not sure what to buy instead, but the 3 wire 20 awg will not work with their LEDs

I bought several BTF-LIghting RGBW LED strips and several of their multi-piece connector kits as I was going to putting lights around a large seating riser with steps. But I needed several long runs of 5-pin wire to connect the LED strips to the controller. I figured I'd be safe if I bought all the parts and pieces from the same manufacturer. Wrong.This 22-gauge wire does not fit into the 5-pin connector pieces that connect the 5-wire ribbon cable to the LED strip. I found out the hard way that those connectors are for 24-gauge wire. You would think "22-gauge, 24-gauge, it can't be that much of a difference?" You'd be wrong. Tried as I did, I could not shove these wires into the connector pieces.I also bought several of the BTF connector kits, these: https://www.amazon.com/dp/B0BNKXZFYB?ref=ppx_yo2ov_dt_b_product_details&th=1 and those come with 24-gauge sections of 5-pin wire.I guess it's my fault for not paying attention. LEDs are not easy to work with by any stretch of the imagination.

I used this to to connect several 5-conductor 10-amp 13-foot RBGW+ COB LED strip lights to each other and to a 40-amp 24-volt power supply. Soft vinyl insulation bends and strips easily, very fine stranded CCA copper coated aluminum wire, wire gauge seems accurate. No complaints.