Fog Lights Compatible with Titan 2017-2018 & Titan XD 2016-2019 with Bulbs H11 12V 55W Driving Lamp Replacement Included Wiring Harness Kit & Switch-1 Pair (Clear Lens)

These are much cheaper than what the dealer or Nissan wants to charge and since they are only supplemental fo lights, I didn’t think I needed top of the line equipment, only for when the weather is actually inclement and I can use the additional illumination. The installation was fast and straightforward for my 2018 Titan SV, but the instructions weren’t that helpful; if you are a true DIY person, you should be able to figure out the installation without really needing complete walkthrough instructions. Your only apprehension should be removing the factory covers on the truck since you don’t really know where the tabs are that secure them to the vehicle, but by looking at the lights, you can probably figure it out.This really is just a basic, halogen set to accentuate your truck looks and the included H11 bulbs matched my factory, non LED light color/temperature. The lights are adjustable if you need to aim them better but mine were set perfectly just beneath the low-beam pattern, which also means you can’t really see the lights when activated from the driver’s seat in the cab. I later upgraded all of my headlight bulbs to LEDs and it was simple to swap out these bulbs too. I would recommend this product and is a great value. If you’re looking for high performance projectors or other off-road capable lights (like spots or superbrights), keep looking. My SV was pre-wired in under the hood/front for the fogs and it was easy to find and plug in.Do yourself a favor and splurge for the OEM Nissan Fog Light switch (25370-1PA0A); it’s expensive ($40+) but it integrates seamlessly with the ECM and your truck should have the pre-wiring under the dash for easy plug and play. If you use the OEM switch, you get all the integration like dashboard fog light indicator, dimming, and any other automatic switching (high/low beam), not to mention less splicing and hacking.Once the lights are clipped in, it doesn’t really seem like it’s a completely tight fit and has just a little bit of play. However, after a few thousand miles with the light in, I haven’t seen any reason to think they will pop out, but there remains a few millimeter of movement but I would not be concerned with it (just like plenty of other things already on your truck). I have lots of chrome on my bumper and grill so this product matches well, but don’t know how it would look of a paint-matched bumper. Product is recommended and is a great value.

fits very well, good quality, easy installation.

So this light for my truck looks great, fits well, and wires plugged directly into the factory wire harness. However I think I might have to contact them about a clip that seems to be loose on the housing. 1 of 4 clips on the passenger side seems to not stay together. I will contact them after this.

this part met my truck spec with the factory wiring except the switch

Looks and fits great, but had to wrestle a couple of the install clips to get it to seat properly. Comes with wiring harness, relay and easy to follow directions.

This fog light housing will pop off. My passenger side does not fit correctly. I am not using them cause they do not snap in snug. They stay loose.

Perfect fit for my 2017 Nissan titan. And they look great Thanks.

Everything looked great and fit in place well as far as the foglight but the bezel was not tight at all. The metal tabs for the bezel trim piece hardly grabbed the bumper face and after 4 days it vibrated loose on the driver side and I lost it on the roadway. The passenger side I used 5200 on to keep it from falling out.