IMPORTANT NOTE:These emblems replace the 82 mm (3.25 inch) stock emblem, which is the size used on the hood on nearly all BMWs built since 1969.It is also shared as the trunk badge on many BMW's.When in doubt measure your stock emblem.We've provided a list of the cars that we know this emblem does fit either the hood or trunk,and a list of known excepts that it will not fit.This emblem DOES NOT fit the following:E12 trunk, E21 trunk, E23 trunk, E24 trunk,E28 trunk, E30 (non-M3) trunk, E36 convertible trunk, E39 trunk,E46 trunk, E90/E91/E92/E93 trunk, E63/E64 trunk, E65 trunk, E82 trunk,E83 X3 trunk, E53 X5 trunk, E70 X5 trunk, E71 X6 trunk,Z1 trunk, Z3 trunk, MZ3 trunk Z4 Roadster hood, Z4 M Roadster hoodThis Logo Fits almost every BMW. Please measure your old emblem and sure yours is same size BEFORE buying.
A**E
Easy to install, looks great
I recently purchased my first project car - a BMW Z3 roadster. One of my first tasks was to replace the faded hood emblem. I was concerned about my abilities to take this on. Before I spend $50 for an OEM emblem and break it in the process, I decided to give this one a try for a fraction of the price. This was perfect for me, a novice, to install. It popped right in via the perfectly sized prongs on the back. One tip to anyone replacing an emblem on the hood: wrap everything well with masking tape - the area around the emblem and the screwdriver you use to pry the old one off. I thought I had everything well-protected, but I ended up chipping a bit of paint around the outside of the circle as I popped off the original emblem. (Paint chips are now another repair project to tackle!)
M**R
It’s definitely not coming off
I put the emblem on my hood and one end was higher than the other. Being plastic I was afraid I’d break the tip off so I evenly pulled it up and broke a tip off one side. Pulled the piece out of the grommet applied super glue wasn’t working but same problem- one end higher. Pulled it up again broke 2nd tip so I wiped the glue off applied sealant and taped it down until sealant cured. I didn’t receive the rear emblem as advertised. It does have a plastic removable non scratch piece which I appreciated. Considering a true emblem goes for around $75 I can live with it for now. I think it looks good considering.👍🏼
C**S
Stay Away.
They sent gromments that don't fit the emblem. I could maybe understand not fitting the vehicle..but not fitting the emblem? I wrote them telling them of the problem and they sent me the same bad gromments. They must not understand written english whereever they are
A**.
Not really straight
Included grommets too big enough for stock hood. Then actual emblem isn’t straight. Vertical line in emblem is slightly pointing to the left of center. But needed to use it for now until a good emblem arrives.Worth it if you don’t care and use double sided tape. But if you care go elsewhere.
J**I
It works
This is a plastic badge, not metal, which is properly reflected by the price. It comes with grommets and fits perfectly on the hood of my E93.
R**R
Total garbage
Absolute TRASH. Do not buy these garbage roundels. They are extremely brittle, and the grommets are made of equally HARD and brittle plastic. Dont waste your money, they dont fit right and they break very easily.
B**Y
Took a chance.
Grommets don't really fit..hard plastic rather than the softer stuff I've seen before. Very cheap. Prob have to replace it in a month. But it's only 8 bucks and it will look ok for a little while.
T**A
Fake BMW markings and emblem is not embossed like original equipment.
Very low quality product. It has a laminated logo on a black base that came slightly separated, had to modify the grommets because they're not the correct size for 328i '07. It lasted under 30 days on my hood. Don't waste your money, you'd be better off buying the original product from your BMW dealership or BMW website.
Trustpilot
5 days ago
1 month ago
