2014-2020 Polaris RZR XP 1000 / Turbo & 900 S Lower Door Insert Panels

Easy installation and works good. Doesn't totally seal everything up like perhaps a ranger oem door would, but for a rzr being able to keep drafts off and mud/dirt out they work great. Plus they're a fraction of the cost of other products doing the same thing. Definitely would recommend trying if you have a rzr and are looking for inserts without spending an arm and a leg for them.

Good product for my Razer 900S. Keeps the mud and water from coming in the gaping hole in the door that Polaris forgot to fill in. Works good and easy to install. Instructions are a joke, but I watched a youtube video the company made and it helped a lot in the process,

Great fit, helps reduce dust from entering cab.

Great product for the price. Install was easy when I watched the video. Directions sucked.

Liked the the product itself, hardware is a bit cheesy but works OK. BUT, abysmal instructions. Haven't rolled a wheel with them yet, (snow in north Idaho, go figger!) But I don't anticipate any issues. I also installed the accompanying door bags, and they look great as well. All of it looks like a good value. Nice stuff!

This is a very good product for the $ - a lot cheaper than the Polaris plastic version. Fit my 2020 Polaris RZR S1000 well. By its very nature, you will need to do some fiddling with the door alignment and latch so that the lower metal panel fits into the corresponding shaped area in the body and doesn't rub in places it shouldn't. Watch the YT video on this product - it will help.There are two places on the metal panel where the edge molding has to make a tight 90 degree turn. To help it make a neat corner and lay flat without puckering up, cut a 90 degree notch in the *wide side* of the molding only (the side that has the adhesive strip). When it is pressed and adhered into place, this notch closes like the corner of a picture frame. But don't cut the entire molding, just the flat side is notched. Also, when pressing in place, don't pull off the red adhesive backing strip all at once. Instead, pull off about 6", press that in place, then pull some more red backer off, and press the next part in place - easier to control this way. Make sure you press the edging so the panel is fully seated in the edging channel. Use a heat gut to get a good bond and press well.

Great product. Easy to install.

Instructions are not the greatest but the video really helps with the installation. Panels seem to be holding up great.