TRIGORILLA PLA Filament 1.75mm 1kg 1 Spool for 3D Printer,Pens Dimensional Accuracy +/- 0.02 mm 2.2 LBS (Transparent)

I got this to print off some lithophanes, which are prints that when there’s a back light it shows a picture through it! And this pla works amazing for it, it prints very high quality straight from the box, I adjusted the temp a little to 185 and could possibly go a little lower as it melts easily, apart from that the tolerances look good and it’s wrapped air tight to keep it moisture free until you open it! Overall really good filament.

I need some golden looking prints, so tried this filament. Measured 1.73mm average diameter, so set filament size to that and used .16mm layer height, 200C/0C on buildtac and rest Cura draft profile settings. 20mm XYZ cube came out exactly 20mm so extrusion fine, no layer lines and really smooth finish. Tried a Benchy, really smooth and shiny gold colour, will treak settings now (i need more retraction as long bowden) and then will be flawless. Really easy to use filament, two successful prints from unwrapping and loading, happy...

Review for the grey filament. I am a model maker and wargamer so I tend to paint my models so I am always on the lookout for good cheap filament in neutral colours. Bought this because it was discounted, sub-£20 at normal price and Anycubic. I try to aim for sub £20/kg filament where possible. Some cheaper filaments have been problematic but not this stuff. Often cheaper filaments can string or be brittle. I did not find this to be a problem with the Anycubic grey. It loaded nicely and printed with minimum stringing and no clogging or partial extrusions at all. I used the whole roll without any problems and immediately bought a second roll which is in my printer now. I have used more expensive filaments that have not performed as consistently as this. While the price point is right this will be on the top of my list for sub £20 filaments.

Nice filament that gives a glossy, clean finish. Thought I’d try a new brand, as I was looking for a darker gray than my usual go to.Printed a test jaws benchy off from Thingiverse on my Creality CR-10, as I usually do with a filament brand I haven’t used before & compared it with a sample from another manufacturer (the white model on the left).Was able to swap the new filament in & print straight off without tweaking the settings. Also very happy with the glossy finish.I’m using SanTubes .2 CR-10 Cura profile, with minimal supports (which cleaned off nicely).

For the price this is pretty good filament, Had some problems with bed adhesion that i didn't have with a more expensive brand, but that's also twice the price per roll, (bit of hairspray fixed that).Colours are bright though thinner layers a bit translucent, but over all decent for the price

The filament prints fine but it is far from being any kind of gold unless your Del Boy ?

Good stuff. .minimal stringing. Smooth printing

Not the best in the world but not the worst either