Solder Wick 1.5m Desolder Wire Copper Braid 2mm Wide, with Flux, 5ft Approx

Although I've only used it once so far, it worked perfectly.

Product is fine, but I had trouble with my soldering iron.

It's a simple product. If you need this, it will work for you.

Works fine, but came in a damaged package which was disappointing

This is a really nice desoldering braid. I was repairing a Fender Ultra Chorus amp and needed to unsolder a couple of quarter inch jacks- one stereo (9 soldered pins) and one mono (4 soldered pins). I used this braid and had the old broken jacks off in a couple of minutes. I do recommend putting a little flux on the braid before use.Also I've seen comments that it worked once and then the user couldn't desolder any more. I suspect the person wasn't cutting off the end of the braid that absorbed the solder from the first removal. Each point you desolder will leave solder on about 1/4" of the braid. Cut this off before trying to desolder the next point and it will work great. Leaving the solder on, even when moving to a "fresh" section of braid just creates too much of a heat sink and really affects desoldering.

it is what it says it is

If you need to remove solder this is it and can not be found any were around here. Price was good. But oreder enough to offset the cost of shipping It more then one item.

This wick doesn’t work in the slightest. It seems that it has absolutely no flux, because it doesn’t wick solder at all. Whereas other brands do a great job at sucking melted solder away and absorbing it into the wick, this wick just sits in the melted solder and does nothing.