🔗 Connect with Confidence!
The Export 48cm SD-Micro SD Card Extender Cable is a versatile and lightweight solution designed to enhance your device connectivity. With a length of 48cm and a male-to-female connector, it ensures seamless data transfer for GPS navigation and DVD players. Built with a durable plastic case and FFC cable, this extender is perfect for both indoor and outdoor use, making it an essential accessory for tech-savvy professionals.
| Brand | FordEx Group |
| Connector Type | Micro Sd to Sd |
| Cable Type | USB |
| Compatible Devices | DVD Player |
| Recommended Uses For Product | Data transfer, Playback |
| Color | White |
| Connector Gender | Male-to-Female |
| Shape | Round |
| Number of Pins | 28 |
| Unit Count | 1.0 Count |
| Item Weight | 13 Grams |
| Specification Met | Oem |
| Indoor/Outdoor Usage | Outdoor, Indoor |
| Manufacturer | BBQbuy |
| UPC | 609207872504 690547111170 690068003800 690068004340 |
| Item model number | FG-AS-56 |
| Item Weight | 0.459 ounces |
| Product Dimensions | 3 x 1.6 x 0.9 inches |
| Item Dimensions LxWxH | 3 x 1.6 x 0.9 inches |
| ASIN | B007WYRO7O |
| Is Discontinued By Manufacturer | No |
| Date First Available | April 24, 2012 |
S**E
Three Stars
Seemed to only work on some ports and not others
M**U
Perfect to eliminate stress on the micro SD card port ...
Perfect to eliminate stress on the micro SD card port on your 3D printer. Most SD card ports are mounted straight to the board, which, over time, can cause the solder joints to break down, causing communication errors and failed prints. And the SD card slot can now be located in an easy to reach spot, rather than on the main board in the middle of every cable on the printer.
M**Y
Worked
Tested it out on a Kindle, and it worked the first time. I hope it continues to work. The cable is pretty long and a little flimsy, so you have to be careful, but again it worked.
K**N
SD not micro SD
works as intended. It should be noted that this is for on SD card and not a micro sd card. unless i was shipped the wrong product. I made it work as i have an adapter, but still
F**N
It didn't work...but it might have been my fault.
I installed this in my 3D printer before I tried it. When installing it there were a few twists and turns where I had to bend the flex cable. I didn't bend it any worse than you might see inside an iPhone (90 degree bends, etc.), but when I finally tried it, it didn't work, and it didn't work when I pulled it out and straightened it.So my advice is to try it right out of the box to see if it works. If it works, bend it if you need to try it again, and then report back here! :-)
A**R
Three Stars
Flimsy, cheap made. Don't fit into as slot well
N**N
Very handy
Still in use daily after almost 2 years
B**D
Four Stars
Works great. Used to extend the micro SD card slot on a 3D printer.
Trustpilot
1 day ago
2 weeks ago
