Nr, keine 1967 Einsteckriegel Stormproof Scharniere gelb chromatiert 1 Paar

Very good. I had no idea that they would be correct and I bought them because they looked the same as may existing hinges. They fitted perfectly. All the holes lined up with the existing holes and when closed the window is perfectly sealed all round. Thick metal so appears to be strong

They arrived earlier than expected and are of good quality. I was unable to purchase these from any DIY or hardware stores, so I was really pleased to have found them on the internet.

These were difficult to find. They are just perfect.

Just what I needed for a project to attach old wooden windows for a cold frame.

Does what it says. It was rather wider than I expected when closed (9mm) but we got over the problem

These double cranked passivated hinges are ideal for when the outer edge of a recessed panel or window frame overlaps the fixed frame. The 4mm spacing (allowing for a protected draft seal) between the mounting faces just happened to be correct for my application where I had a slightly wider overlap.The hinge mechanism is a bit too sloppy and this is what loses it a star for general usage, but it will do in my application.I actually bought five different pairs of hinges from various suppliers to find a suitable pair to fit, simply because almost none of the suppliers give proper measurements or a drawing showing them, and double cranked hinges tend to be uncommon.The hinge dimensions are as follows (all +/- 0.5mm).Length of hinge: 64mm (66mm across the hinge pin)Overall width when closed: 31mm (conventional measurement with the holes visible)Overall depth when closed: 25mm (the crank, holes not visible)Gap between mounting plates for the draft seal when closed: 4mmSpace required to accommodate mounting plates when closed: 8mmWidth of outer (moving) mounting surface: 23mmWidth of inner (fixed) mounting surface: 21mmDistance from hinge barrel to outer (moving) mounting surface: 15mm (the overlap in my application with hinge barrel exposed)Diameter of hinge barrel: 10mm (for a total of 25mm of overlap plus barrel)Distance across hinge barrel to inner (fixed) mounting surface: 17mm