Westmell 60pcs Stainless Steel Wire Brushes Wheel Cup Pen Cleaning Brush Set Polishing Attachment Kit for Dremel Die Grinder Rotary Tools (1/8 inch Shank)

I originally purchased basically the same set of these for my rotary Dremel from a different manufacturer and sent them back in disgust after blowing through 20 of them in about 15 minutes. The mistake I made was using them on the highest speed setting, during which the tiny wires fly out and stick in everything, your skin and clothes and anything that will hold them, and the whole wheel would wear out and be useless in about 2 minutes. They are a nightmare to get out of clothes as you have to hand-pull them out one by one. When I received this set I put the speed setting on my Dremel down to 4, instead of the 10 I was originally using, and it worked pretty good. There were a couple wires that I could feel flying out but one wire wheel lasted for the entire mini project I was working on removing rust from small mechanical parts. So remember, to get the most out of these USE A LOW SPEED SETTING!

These will fall apart when used and the bristles will fly into your eye. WEAR EYE PROTECTION! That said, they were cheap and I didn't expect more than one use. Try putting a drop of epoxy or super glue where the brush connects to the shaft to make it last longer.

Cheap and ok of a product. Works for what you need although one word of WARNING wear safety glass's. These things are not the best so they fling out little metal wire's everywhere when used.

Yea, their made in China, but at this price I can afford replace them when necessary. That's the only reason I didn't give them an overall 5.

I like using these brushes. It is important to keep the tool speed down and maintain a light touch or the brush just gets eaten.I use them to clean up metal I welded.

Doesn’t take long for the wires to come out, at that point you’ll have wires in everything and a PITA to remove.

They work great, only issue is the round ones, the wires fly out of them

Be prepared for shrapnel! Wear your safety gear.If your rotary tool is not a variable speed forget these, and most of the brush accessories.Just remember to use a slower setting for these. Even 5000 rpm is a little too fast for these brushes to handle effectively.If you keep the speed low they are an effective polishing tool, but if you are trying to remove paint or stain from metal or other substrates, this is not the product that you want.

These brushes are poorly made. Any kind of effort/speed put to them results in the bristles flying every where. Don’t use these without safety glasses. They are terrible!